Summary
This is a quick printing, easy to use snap on light cover for the PixelPRO TW-283 wireless camera receiver. (The receiver may say "TW-283RX", but it is the same thing)

This can be used for many purposes. In my case, I want to use it for wide-angle wildlife photography so the flashing status light doesn't spook the animals

It took me quite a few prints to get the design to fit nicely. It seems like there is a difference in measurements between the left side and the right side of the receiver. This means that the quality control of the product doesn't seem to be that high. So, I think the dimensions between different batches of receivers might also slightly fluctuate, so yours might not fit as well as mine

If you have any questions, feel free to write a comment

Quick vid of the final print: https://youtu.be/NmgiQx-CY54

Print Settings
Printer brand:
Creality

Printer:
Ender 3

Supports:
No
Resolution:
0.16

Infill:
--

Filament material:
PLA

Filament brand:
eSun

Filament color:
Black

Notes:
It isn't a hard print, and will probs be fine with most settings. Just make sure the dimensional accuracy is quite good for the best result

I added some fuzzy skin for a nice texture

Tags
License
CC BY-SA
PixelPRO TW-283 Snap On Light Cover V1.9 | No Supports
by BramBakker is licensed under the Creative Commons - Attribution - Share Alike license.